Martijn


Martijn


Joined 06th October 2019

3 Forum Threads

Here are the most recent threads Martijn has started in the Forum:

problem with printing foot

Posted 11:49:15, 23rd November 2019   |   № 174

hello, i have a print problem with the foot (robotical one ) i slice it with cura and check it online with a gcode tester , everything is oke, when i start printing on my aneta8 the print starts fine, but near 10-15% the print stops, every time on same place..... someone has this prob also ?

hope to hear

thanks

View Thread

feet

Posted 18:43:31, 10th November 2019   |   № 173

Are the two new robotical feet compatible (3d printable ones ) for the marty springs ? (the ones that are in the screw, bolt and sticker set ) the feet seem to be different from the molded ones i see in the instructions part...

hope to hear and if the springs will fit in this 3d printable feet....

View Thread

Servo's

Posted 18:25:37, 13th October 2019   |   № 169

hello community,

which cheaper one servo types can i use for the marty that will fit and work as the one recommended ? i have to pay a lot of sending costs by fed ex to get the ones sold on the site to the netherlands...

someone have a tip

thanks

View Thread

0 Forum Comments


No comments yet…